| LTR INSTRUCTIONS
- click
here for printable instructions
Shake LTR well before using. Tap tiles lightly
with a rubber mallet to determine that the tile
has hollow areas.
Next, drill into the grout joint around the
loose tile with a 1/8" masonry dril bit.
Drill down slightly deeper than the thickness
of the tile. Drill 4 to 8 holes around the loose
tile. Be careful not to drill into the tile.
Use a vacuum or shop vac to clean away all
dust and debris from holes and surrounding area.
Then use a caulk gun to apply the tile adhesive.
Insert the tip directly into a drilled hole
and inject adhesive with light pressure (if
having trouble or in cold weather, soak the
LTR tube in 70-90 degree water for 30 minutes).
Tap the tile with the rubber mallet. Rotate
the caulk gun to the other holes and inject
until the adhesive begins to come up through
the holes. Clean excess with damp sponge or
rag. When done, close the cartridge cap with
cap provided.
Place a weight, such as a bucket of water,
on the reset tile and allow 24-72 hours for
adhesive to cure, depending on temperature and
humidity. Clean-up excess adhesive around the
tile with a damp sponge or rag.
Fill holes in grout with matching caulking
or grout. |
